Abs Issue

[alanfavell]

How I do mine....

 

Heldi in by 1 bolt.

Wheel does not need removal

A gentle tap on the tang the bolt goes through to rotate the sensor in its housing and then remove the sensor by pulling like you were defusing a bomb.

 

Simples if it's not corroded in ala BMW. I think the 1300 yam sensors are the same but not sure anymore

Prone to corrosion if not part of your service routine. If it is stuck by corrosion - good luck and iI'm not responsible for anything you break.

 

When / if you remove the sensor take care not to bash the magnetic sensor end and clean it before assembly keeping the grease off the sensor end.

[attachment=o15413]