How to replace the emulsion tubes on a Mk1

[m3psm]

<!--quoteo(post=46736:date=Sun 8th Jul 2007, 08:09 AM:name=dapleb)-->QUOTE(dapleb @ Sun 8th Jul 2007, 08:09 AM) <{POST_SNAPBACK}><!--quotec-->Good work. No problems undoing the screw for the float bowls while they were on the boike, I know they can be a real pain? Prefer to take mine off and work on ze bench though its a bit more work.<!--QuoteEnd--><!--QuoteEEnd-->
I left the carbs on because I was racing a rain cloud. ould have prefered to do it on a bench (if I had one) and give them a good clean too and oil the cables.

A couple of the float bowl screws were tight but a good stubby screwdriver got them of. When undoing any tight screws you just need to make sure the srewdriver is a perfect fit, otherwise you round off the screw. That's when the problems really start.

I'll hopefully have a fully kitted out garage and workshop in the next couple of months (subject to planning ) so everything should be a little easier in future