Ejk - Electronic Jet Kit (Alternative To Power Commander)

[fruitcake]

 

This is intriguing. Has anyone used anything like this to set up Carbs on a TDM 850 ?  I might actually go for this. All I need now is someone to weld the Sensor boss into place on my downtube.

 

Not a TDM, but I did set up my ZRX1100 carbs using it.

 

The jets from the previous owner didn't suit the exhaust or K&N pod filters they'd put on.

 

I tuned the jets perfectly using the AFR gauge - they really are good if you don't mind the cost outlay.

 

Yeah the boss is a bit of a pain if you don't have welding capabilities - I have a mig so it was easy enough to do, but I have previously braised a boss on in when I had no choice (and just to see if it would work) - it's not ideal but as it' s usually in the area before the link pipe, it's not super hot and a braised joint is fine if you're at a push.