Front-Sprocket: The Right Size Of This One --.. Should I Take A Thick One Or The Thin One

[steve27bha]

I have asked before - why not use a part designed for the TDM?

 

This item will need various changes - big centre hole, six holes to bolt to hub. Can you do this, accurately?

Also the item is in Aluminium which will wear rapidly unless it is hardened.

 

There is a steel JT sprocket available for less cost than your item:-

https://www.motomoto24.com/rear-sprocket...tr300.html

 

OK it is 39 teeth, but perhaps a 37 cannot be made without weakening the supporting material too much. The dimensions are for the JTR 300 series sprockets, which apparently also fit a range of Honda bikes! I can't find a JTR 300.37

 

I note you do not have a TDM yet according to your avatar caption.