What Have You Done To Your Tdm Today?

[steve27bha]

Do it on the end of a 3/8 socket and easy to post too, just need a long extension bar.

I assumed it'd be a hex.

 

 

Dont have a photo but whatever you use you simply need to cut the end into a wedge shape so that it wedges between the flat side of damper rod and the wall of fork lower, this will prevent twisting, if you fit it to a work bench as i did do NOT tighten the bolt through the caliper bolt bracket up tight, just firm as you dont want to snap it, set up like this made tightening those bolts up a doddle..

 

Edit... i made my wedge approx 2-3" long.

 

Howzabout this item - wedge in metal on a 3/8 socket. £16 eBay

 

https://www.ebay.co.uk/itm/JMP-Fork-Damp...0290.m3507

This post was last modified: 07-06-2020, 10:28 PM by steve27bha.