What Would You Buy Instead? (Hypothetical Scenario)

[fruitcake]

Following yer TDM blog on CMC Nog. Sure was a rusty looking piece of poop to begin with.  Coming along nicely though. :good:

 

Actually just bought some Abranet, well, I went for some Pronet as I could get a mixed pack, delivered just now and looking forward to trying it out.

 

Thanks, yeah it sat in my mates barn for 2 years (it wasn't great before) which left it looking a bit unloved.  Think I got very lucky with the engine stud but fingers crossed valve clearances etc all going well and it should look like a 2007 bike again soon.

 

Will check out the pronet, guessing they're all much the same and just the brand names, but yeay very impressed with the stuff.  I'll probably still use traditional fine wet and dry for the final sanding of paint with a bit of soapy water before polishing, but this is great for the early stages.  One thing I have noticed is oil and grease ruins it a bit, so best to use on dry parts if you can.