850 Destruction

[dablik]

[attachment=o12606]

And so it begin's, give a monkey a wrench and see wot happens.

[attachment=o11935]

Got two buckets stuck in-situ on #1 cylinder, magnet pulled the rest out but even a pair of long nose pliers wont have these out so will address that a bit later on, prolly end up needing 2 new ones.

[attachment=o11936]

Thought these might have been coked up a bit more,not to bad really although piston pin on cylinder 2 took some persuading to free up.

[attachment=o11937]

Barrels are smooth with a very slight lip at the top right of both cylinders.

[attachment=o11938]

Lookin a bit polished.

[attachment=o11939]

Oil pump cover fookin siliconed along with the 2 dowels, i mean really wots the point a gasket's not expensive, could'nt budge the feed pump after undoing the 3 screws which hold it on, according to Haynes it should slop off but, me thinks maybe the cam chain guide needs to come of 1st..

 

Thought i would take the Rotor of 1st this morning then changed me mind and decided to strip ala Stud's suggestion from his Blog and anchor same like wot he did.

 

Knees are knackered now me thinks a beer may help.

This post was last modified: 05-10-2019, 06:37 PM by dablik.