What Have You Done To Your Tdm Today?

[Matlock]

Take the clocks off Chris and flip em over, twist and pull a bulb out then refit new one, that's it, dont really need a pic.

I wish it was that simple Cliff. Sadly I didn't take pictures Chris and there's nothing in the service manual about this. The diagram in the parts catalogue is useful though and there's some stuff on JBX's site about fitting LED replacements with good instructions (I didn't bother with LEDs).

1. Side panels, screen, infill panel & front cowling off.
   
2. Dash unplugs and is retained by three screws underneath.
   
3. Put it on a clean, clear work surface. Flip it over, remove 8 crosshead screws, flip it back over (so clocks are facing up) and gently pull apart.
   

Dash bulbs are two T5 push ins, 2W rating (though I used 2.3W from ebay). One is to the right of the speedo face in plain sight, t'other is under the speedo, at the edge at about 7 o'clock. That one's a bit awkward if you have big hands. Reassembly is reverse. 

This post was last modified: 30-12-2017, 05:04 PM by Matlock.