What Have You Done To Your Tdm Today?

[fixitsan]

Thanks fixitsan for replying. The m/c is used but in very good condition. The calipots are recently rebuild, pistons in very good condition also. Nothing seized. All the pins are clean and smooth.

I did a re-bleed tonight and no bubbles. Lever feel is good at the moment, not mushy or wooden. I'm going to do another test run this morning and hope for the best. What do you think? G.

 

I would pull the lever hard, then release it. When you release the lever the pads should be withdrawn from the disk a fraction, enough to wiggle them on the pins a tad.

 

If they don't pull back there could be crud in the fluid causing a blockage at the caliper or the m/c.....or the m/c perhaps has a faulty seal

:rotflmmfao:  yeah... I know... I did ask it for a cup of tea and slice of :cake eating:  but no reply! Must be broken  :punishment:

 

Then you gotta get a lens  :badgerrock:

 

 

The lens is everything !    There's a reason  some 50 year old lenses are still in use today when more modern counterparts are available !