Reviving A -99 Tdm 850

[anda3243]

Welded the bushing properly, and welded on some flanges to make it stronger.




The flanges were grinded down somewhat later


The left side bracket

I bought a bolt that fitted. M12 x 1,25
I am in need of a better looking bolt,


The bolt was fittet with a bushing, same as the other side. And the bracket grinded and fitted.


Then welding it to the bushing and fitting the engine mount. The engine is hold in place by the rear mounting points. Note that the bushing takes up some "axial" play. I dont need to bend the bracket to make it fit properly.


Welding the mount to the frame


Adding reinforcement flanges, and welding the bushing properly.




Grinding down the flanges and cleaning both brackets.


Then painting. First ground, then silver.


Also ground paint on the welded mount on the frame. This was also spray painted silver later.