Just replace mine today, discover that the carb floats high are set at only 11mm! (without compressing the springs, just like factory pro says you should measure them), needles are set at the second from top position, I'm going to leave everything as is since the bike was running fine except for horrible fuel consumption (8,5L per 100km), don't have a vacuum gage so balancing carbs will have to wait [img]style_emoticons/<#EMO_DIR#>/sad.gif[/img]
Good and bad? news was to discover the throttle cable was ready to snap! so, will have to wait till I get one to see how the new emulsion tubes work.
Any tips on replacing the cables? I guess I'll have to grease them at the handlebar end... don't know how you take that apart [img]style_emoticons/<#EMO_DIR#>/unsure.gif[/img]
cheers
Good and bad? news was to discover the throttle cable was ready to snap! so, will have to wait till I get one to see how the new emulsion tubes work.
Any tips on replacing the cables? I guess I'll have to grease them at the handlebar end... don't know how you take that apart [img]style_emoticons/<#EMO_DIR#>/unsure.gif[/img]
cheers
Sent from my secret Dick Tracy watch