Forums
What Have You Done To Your Tdm Today? - Printable Version

+- Forums (https://www.carpe-tdm.net)
+-- Forum: Start your Engine (https://www.carpe-tdm.net/forumdisplay.php?fid=6)
+--- Forum: All About TDM (https://www.carpe-tdm.net/forumdisplay.php?fid=22)
+--- Thread: What Have You Done To Your Tdm Today? (/showthread.php?tid=8583)



What Have You Done To Your Tdm Today? - Snowbird - 28-09-2019

Quote: 

<span style="color:#434343;font-family:Verdana, Arial, Helvetica, sans-serif;font-sizeConfusedmall;"><span style="font-weight:bold;">Note:Light do not direct line of sight,so as not to affect the front of the drive of the vehicle traffic accidents.
</span></span>
You gotta love chinglish! Lol

I note it says 125W so I would run them through a relay or at least check current draw with a multimeter first.

At £10.79 I'll give a pair a go.




What Have You Done To Your Tdm Today? - alanfavell - 30-09-2019

Let us know what you think of them.


What Have You Done To Your Tdm Today? - steves100uk - 30-09-2019

Quote:You gotta love chinglish! Lol

I note it says 125W so I would run them through a relay or at least check current draw with a multimeter first.

At £10.79 I'll give a pair a go.








125÷12= amps


What Have You Done To Your Tdm Today? - alanfavell - 30-09-2019

Tested the standard screen with MRA touring flip thingy - loads quieter :good:




What Have You Done To Your Tdm Today? - Snowbird - 02-10-2019

Spots arrived today and cheap chinese junk they certainly are, connect once for full, connect again for low, connect again for a pointless flash mode (wtf is all that about?), that said high is bright for sure, at 12V supply I measured 0.31 Amps which says to me 3.6Watts so no need for a relay, low came up at 0.08Amps.

I'm sure I can find a use but not good to have wired in to the light switch with the 3 modes.




What Have You Done To Your Tdm Today? - fixitsan - 02-10-2019

Quote:Spots arrived today and cheap chinese junk they certainly are, connect once for full, connect again for low, connect again for a pointless flash mode (wtf is all that about?), that said high is bright for sure, at 12V supply I measured 0.31 Amps which says to me 3.6Watts so no need for a relay, low came up at 0.08Amps.

I'm sure I can find a use but not good to have wired in to the light switch with the 3 modes.
 

 

Been down that road myself. Live and learn eh ? Smile



What Have You Done To Your Tdm Today? - Snowbird - 03-10-2019

It seems from a quick googling that a 10k resister across one of the capacitors makes them come on high each time unless you switch on and off quickly, I'll have to have a go.




What Have You Done To Your Tdm Today? - velf2003 - 03-10-2019

Fitted crashbars and a centre stand. Manufactured in Poland, by Rafal (RM-G.PL) 

Very neatly made, easy to  mount.

 

http://www.rm-g.pl/yamaha-tdm-900-gmole/

 

Given the quality (not only the product, but also the fast and correct contact via email) I find the  product good value for the money.

 

Me  happy!



What Have You Done To Your Tdm Today? - bjorge - 04-10-2019

Refitted inner lining this morning; 2 degrees outside. Thank god for heat grips !




What Have You Done To Your Tdm Today? - fixitsan - 04-10-2019

Quote:It seems from a quick googling that a 10k resister across one of the capacitors makes them come on high each time unless you switch on and off quickly, I'll have to have a go.
 

There are a lot of different types of the circuit board and of instructions, Some suggest soldering a resistor at U1, some say short out U3, so it's a matter of hoping you can find instructions for your particular type of PCB



What Have You Done To Your Tdm Today? - drewpy - 05-10-2019

Fitted rear brake pipe from BTR and had to strip and clean calliper too. That was fun, not


What Have You Done To Your Tdm Today? - Matlock - 05-10-2019

102,000 miles service started today  Big Grin  Changed the oil and filter and front fork oil. The usual pickled-onion water came out of the forks, replaced it with some Dextron III ATF oil as recommended by JBX. First time I've used this, so I'll see how it goes and report back. I was going to replace the front wheel bearings, but the front tyre was more worn than I thought, so I'll get a new tyre fitted in the week and replace the bearings then. I just checked my records and I've had 12,000 miles out of the front, well chuffed  :good:  102,000 miles out of the front wheel bearings is pretty good too  :rotflmmfao:




What Have You Done To Your Tdm Today? - bjorge - 07-10-2019

Scraped ice this morning  :unsure2: but found muffs and had a nice driva for work  :pimp:




What Have You Done To Your Tdm Today? - TKH - 07-10-2019

Had rear wheel lock up while braking. Car stopped bike. Confusedorry: . Waiting to get it in for a quote for repairs. Sad

No human damage but car and bike didn't fair as well.




What Have You Done To Your Tdm Today? - alanfavell - 07-10-2019

As long as you're ok and I hope damage is minimal




What Have You Done To Your Tdm Today? - Studley Ramrod - 07-10-2019

Sheeeet.  Sorry to hear that matey. Sad  Glad you're ok though.  Them 9'er rears do lock up really easily eh. 



What Have You Done To Your Tdm Today? - dablik - 07-10-2019

Oops easy done in the heat of the moment, good your okay and hopefully bike's not to bad.




What Have You Done To Your Tdm Today? - tdm92 - 07-10-2019

Quote:Them 9'er rears do lock up really easily eh.
+1



What Have You Done To Your Tdm Today? - LAURENCEAUX - 07-10-2019

Quote:Had rear wheel lock up while braking. Car stopped bike. Confusedorry: . Waiting to get it in for a quote for repairs. Sad

No human damage but car and bike didn't fair as well.
 

Glad that you're OK fella and I hope you get up and running again. Good luck with the insurance shysters!



What Have You Done To Your Tdm Today? - TKH - 07-10-2019

Thanks Guys, I appreciate your comments.