+- Forums (https://www.carpe-tdm.net)
+-- Forum: Start your Engine (https://www.carpe-tdm.net/forumdisplay.php?fid=6)
+--- Forum: All About TDM (https://www.carpe-tdm.net/forumdisplay.php?fid=22)
+--- Thread: What Have You Done To Your Tdm Today? (/showthread.php?tid=8583)
Pages:
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
211
212
213
214
215
216
217
218
219
220
221
222
223
224
225
226
227
228
229
230
231
232
233
234
235
236
237
238
239
240
241
242
243
244
245
246
247
248
249
250
251
252
253
254
255
256
257
258
259
260
261
262
263
264
265
266
267
268
269
270
271
272
273
274
275
276
277
278
279
280
281
282
283
284
285
286
287
288
289
290
291
292
293
294
295
296
297
298
299
300
301
302
303
What Have You Done To Your Tdm Today? - alanfavell - 17-03-2019
Finished the aux wiring/distribution board/fusebox build & began disassembly of TDM for fitment of same. I'll do the shims while it is stripped, as a couple of inlets were tight but serviceable last year. CSM, throttle bodies blah blah adjusting/service too.
What Have You Done To Your Tdm Today? - JMC - 20-03-2019
Having a bridgestone battlax T30 evo fitted on the front on saturday, changing from a sportmax 2 that decided to go out of shape and cause some wobblesÂ
Anyone use the evo's ?
What Have You Done To Your Tdm Today? - dablik - 20-03-2019
Yea one of our members uses Evo's, in Oz i think, seem to recall very good review of them though.
What Have You Done To Your Tdm Today? - ramotdm - 20-03-2019
used them on the VFR1200, good tyres, in fact just had a pair delivered today for me Blackbird :good:
What Have You Done To Your Tdm Today? - JMC - 20-03-2019
Cheers lads
What Have You Done To Your Tdm Today? - poppykle - 21-03-2019
I changed to a pair of Battlax Sport Touring T31 about six weeks ago. Felt good for the first 250km, had the rear edge to edge on the Putty Road in a group ride with friends. Unfortunately a combination of gravel road, a big ditch and target fixation stopped my testing of the tyres.  Bike should be back this week and the plate in my clavicle should be good in about two months.Â
What Have You Done To Your Tdm Today? - dablik - 21-03-2019
Ooch ouch ow, "a bad workman always blames his tools"
hope your on the mend and did'nt bust the bike up too much.What Have You Done To Your Tdm Today? - Atesz792 - 21-03-2019
Quote:I changed to a pair of Battlax Sport Touring T31 about six weeks ago. Felt good for the first 250km, had the rear edge to edge on the Putty Road in a group ride with friends. Unfortunately a combination of gravel road, a big ditch and target fixation stopped my testing of the tyres.  Bike should be back this week and the plate in my clavicle should be good in about two months.ÂOops. Get well soon!
What Have You Done To Your Tdm Today? - alanfavell - 21-03-2019
Be better sooner.
What Have You Done To Your Tdm Today? - fixitsan - 21-03-2019
Quote:I changed to a pair of Battlax Sport Touring T31 about six weeks ago. Felt good for the first 250km, had the rear edge to edge on the Putty Road in a group ride with friends. Unfortunately a combination of gravel road, a big ditch and target fixation stopped my testing of the tyres.  Bike should be back this week and the plate in my clavicle should be good in about two months.ÂÂ
Ouch, but lucky you got a plate on the clavicle. Mine went pop in September and they left it to heal is it's crazy angle, so I've now got a huge lump of new bone growth sticking through my shirt where new bone has grown to fill the gap.. Doctor said if it causes any serious issues they can just break it again and plate it !  I wish they'd have plated it because the new joint kept breaking every few days, just by moving my arm or rolling over in my sleep...it stings a bit !
What Have You Done To Your Tdm Today? - velf2003 - 21-03-2019
Quote:Having a bridgestone battlax T30 evo fitted on the front on saturday, changing from a sportmax 2 that decided to go out of shape and cause some wobblesÂUsing my second pair of T30 evo`s now. When the are due for replacement, I will have Pirelli Angel GT`s fitted. The Pirelli`s perform better in the wet, and have less `discomfort/feeling of sliding` when passing a bitumen repair on an asphalt road in the wet.
Anyone use the evo's ?
But the T30 evo`s most certainly aren`t a bad choice in my opninion.
What Have You Done To Your Tdm Today? - chrisr - 23-03-2019
Spent the morning at Steve Jordan motorcycles in Bookham. After trying to remap my pc3 Steve decided it wasnât working at all and took it off, he then had a think and another go at fitting it and found that some idiot (!) had managed to fit it wrongly, after a couple of hours of remapping the result is a perfectly smooth TDM with no snatching whatsoever, Iâm finally very happy with my newish bike! In my defence the plugs/sockets I fitted it to were the same fitting and colour (which had been changed by Yamaha since my 04 bike)
What Have You Done To Your Tdm Today? - JMC - 23-03-2019
Got the evo fitted on the front today, the rear has only 1700km on it and it feels like a new bike super handling again
I also had a good look at the tracer gt, the fairings do look a bit cheap and it's a bit expensive at only 2 grand less than a full spec africa twin
What Have You Done To Your Tdm Today? - Karpo - 26-03-2019
Just fitted Barkbusters Storm S1 set on my 9er. Web page said they wouldn't fit the 2010 model, but lo and behold, they did.
I did have to partially dismount right mirror assembly to slide the clamp under the brake fluid reservoir. Easy enough.
Â
Now to wait for a rainy day to really test them out. Today I'll have to settle for wind gusts of over 50km/h. I can already tell these are much better than the 4⬠eBay hand guards I tried first.
Â
Earlier last week I also managed to remove most of the snatchiness on low load sustained revs by simply adjusting the CO settings much leaner. Should have tried that earlier. Doh!
What Have You Done To Your Tdm Today? - drewpy - 27-03-2019
changed oil and filter as not ridden since July as had a new hip.
Â
In readiness as off to Wray Bike night next Thursday, weather permitting
What Have You Done To Your Tdm Today? - Andy25 - 29-03-2019
Re- done 3 puncture's on the Rear tyre using Stop & Go Pocket Tyre Plugged Kit - previously used Cargol Turn + Go but had a slow leak
Then took it for a spin around Loch Lomond
On the way Home it Spat out the R / Hand Spark Plug @ 70 mph on the outside lane of A9 heading up hill between Stirling + Perth
Limped home on One Cylinder
No obvious damage - Will have better look tomorrow
Andy
What Have You Done To Your Tdm Today? - fixitsan - 29-03-2019
Quote:Re- done 3 puncture's on the Rear tyre using Stop & Go Pocket Tyre Plugged Kit - previously used Cargol Turn + Go but had a slow leakÂ
Then took it for a spin around Loch Lomond
On the way Home it Spat out the R / Hand Spark Plug @ 70 mph on the outside lane of A9 heading up hill between Stirling + Perth
Limped home on One Cylinder
No obvious damage - Will have better look tomorrow
Andy
Â
That's really unlucky. Did you go all the way back to Dundee like that ? Good going if you did !
What Have You Done To Your Tdm Today? - Andy25 - 29-03-2019
Quote:That's really unlucky. Did you go all the way back to Dundee like that ? Good going if you did !
Yeah
Rode all the way home like that
Mainly because I didn't have a clue about what was wrong
The Bike was making a hell of a noise , fuel light came on so stopped in Perth and stuck 6 quid in 20 miles later fuel light on again !
Went to Skinner's motorcycle's as soon as I got to Dundee he reckoned that the plug threads may be stripped but it would be a week or two before he could have a Proper look !
So just nursed it home and Will check it myself
What Have You Done To Your Tdm Today? - fixitsan - 30-03-2019
Quote:YeahÂ
Rode all the way home like that
Mainly because I didn't have a clue about what was wrong
The Bike was making a hell of a noise , fuel light came on so stopped in Perth and stuck 6 quid in 20 miles later fuel light on again !
Went to Skinner's motorcycle's as soon as I got to Dundee he reckoned that the plug threads may be stripped but it would be a week or two before he could have a Proper look !
So just nursed it home and Will check it myself
Hope it's not a stripped thread
Â
Â
Â
Â
Â
Today I fitted the repaired bodywork from Muddy's old bike..
Â
[/url]56226056_2684495688233002_1658299474419646464_n by Chris Barron, on Flickr">http://
![[Image: 47499229681_41b6569ac2_b.jpg]](https://farm8.staticflickr.com/7904/47499229681_41b6569ac2_b.jpg)
56226056_2684495688233002_1658299474419646464_n by Chris Barron, on FlickrÂ
Â
Â
[/url]55744547_2684495834899654_5789550820483661824_n by Chris Barron, on Flickr">http://
![[Image: 32557032057_0d80d6d819_b.jpg]](https://farm8.staticflickr.com/7915/32557032057_0d80d6d819_b.jpg)
55744547_2684495834899654_5789550820483661824_n by Chris Barron, on FlickrÂ
Â
Â
Â
[/url]55730902_2684495751566329_2204273024142671872_n by Chris Barron, on Flickr">http://
![[Image: 40533183353_0a679ecfff_b.jpg]](https://farm8.staticflickr.com/7912/40533183353_0a679ecfff_b.jpg)
55730902_2684495751566329_2204273024142671872_n by Chris Barron, on FlickrÂ
Â
[/url]55661529_2684495468233024_3451571985493000192_n by Chris Barron, on Flickr">http://
![[Image: 32557032747_fd14f9bba0_b.jpg]](https://farm8.staticflickr.com/7888/32557032747_fd14f9bba0_b.jpg)
55661529_2684495468233024_3451571985493000192_n by Chris Barron, on FlickrÂ
Â
Â
I think the colour of the hydrodipped parts clashes with the nice dark galaxy blue of the other panels but it's good enough until I find another idea
Â
Â
Â
Â
This was the upper fairing before I used hot staples and 3D printed brackets to repair it
Â
IMG_20190207_160945 by Chris Barron, on Flickr">http://
![[Image: 33170793258_6dee3fb608_b.jpg]](https://farm8.staticflickr.com/7814/33170793258_6dee3fb608_b.jpg)
IMG_20190207_160945 by Chris Barron, on FlickrWhat Have You Done To Your Tdm Today? - Andy25 - 30-03-2019
Nice work Fixitsan
Well today I put the spark plug back in - nowt only firing on one cylinder
So plug out new plug in changed plug cap back to original etc- cos I had been struggling to get cap on then off then I managed to pull the Lead out of the cap
End result It's Alive ! Running fine - quick trip for Fuel all Ok
Question
What's everyone else using to get that R / hand plug in / out on a mk 2. ?
What am I missing I'm using a 17 mm ratchet spanner on the top of the plug spanner but it's a very Slow process
So what's the quickest way ?
Andy